base maps

[red-em1-si]

where can i get a base map. looking for b16b

[bluebomber]

Which ecu?

[Sikocivic]

Here you go;

http://www.xenocron.com/bins/

[TurboEF]

I have a .bin for a Z6, but it looks like you're already covered.

[randY49]

Here you go;

http://www.xenocron.com/bins/
That is thee best place to look for bins. You can also check out forum.pgmfi.org for more information.

[red-em1-si]

so i see theres a b16a "cheoh.bin" and a type r "Crome-Stock-TypeR-P73-240cc.bi" so which one do you guys think is best for my set-up. I have a b16a2 with ctr cams, sk2 mani, type-r throttle, rmf narrow header 4-1, 3" short ram intake with viscosity thing, and stock bottom. I'm leaning towards the type-r until i get so cash to get a better tune. but any other suggestion would be helpful.

[TurboEF]

...short ram intake with viscosity thing...

What?!

[Tou]

Probably meant velocity stack??

[TurboEF]

Probably meant velocity stack??

That's what I figured... but it sounds like you have an oil leak in your intake. LOL

[red-em1-si]

its the stack. the name just didnt come to mind when i was writing

[Tou]

xenocron or phearable have basemaps.

[bluebomber]

Tune it yourself

[Maperformance]

With your setup i wouldn't drive that car beyond half throttle and over 4000rpm without getting it properly tuned.

[red-em1-si]

^^^ dam really i might come to you place to get the tune or maybe full blown to get tune. just need it to be a daily driven car but okay race car.

[Sikocivic]

A base map is just a starting point to get the car up and running so you can get it tuned. Pick the one that is close and drive the car carefully to the tuning shop.;)

[red-em1-si]

will i heard of people using stock ecu on their mild tune motor and it runs fine.

[randY49]

will i heard of people using stock ecu on their mild tune motor and it runs fine.
How mild?? Were they using an FMU to manage fuel?? The car might 'run fine', but my guess is it's not running safe.

[Maperformance]

will i heard of people using stock ecu on their mild tune motor and it runs fine.

Running "fine" and running "right" are two completely different things.

[red-em1-si]

will dont the new cams need to break in b4 reving them hard? So i was suggesting breaking them in with the stock ecu or a ecu with base map until it breaks in then get a tune.